2 Other Manuals & Support & Drivers

Support resource

Enable Device in BioExplorer – Wiz

Install Driver After you have run your setup file(s) provided by Brain-Trainer you are ready to connect your biofeedback device (amplifier). You may have already installed a file called pnWirelessDongleDriver or Amplifier setup, etc. If not, it may install automatically following the next steps.     USB dongle key must be plugged in. BioExplorer software will […]

Support resource

Q-wiz Testing

If you suspect the trouble you are having is with your Q-wiz, there are a couple tests you can do. For EEG:  1) No sensors – test tone; 2) Sensors in conductant- flat line. EEG testing   HEG testing               

Support resource

Alpha/Theta Troubleshooting

Audio files do not play (BioExplorer) Check to see if audio files are loaded and available. If not, load them yourself and save the design. Select Tools | Volumes, double-click on “Chants” audio player If using .mp3 files, replace them with .wav files. Design fails to open/BioExplorer crashes when opening A/T design (BioExplorer) On another […]

Support resource

nIR Headset

Handle the nIR HEG headset with care. Bending the band or putting undue strain while handling it can damage the board inside. Unfasten the velcro band when putting it on to avoid additional stress. Store the headset without bending, ideally slightly curved, almost flat. Issues Below are some possible issues one may experience with the […]

Support resource

BxShadow For BioExplorer Installation

Your setup file should already be saved to your computer and extracted (unzipped). Double-click on the BxShadow .msi setup file. Advance through the setup wizard until complete. You should find an icon shortcut on your desktop to launch the BxShadow application. BxShadow User Guide (1.01 MB)

Support resource

LIFE/HEG Troubleshooting in BioExplorer

Blank screen, no control panel or landscape Solution: Run latest LIFE setup file Open design from DocumentsBioExplorerDesigns See Loading flash files: Flash storage message Solution:  Change flash storage settings Failed to create Flash Player. Macromedia Flash version … must be installed. Close BioExplorer. Follow instructions on restoring flash. Open BioExplorer again. Flash files not fully […]

Support resource

BAL4C RH Bipolar – Electro-Cap BioExplorer (Q-wiz)

1. Connect amplifier to computer Connect your amplifier cable into your amplifier and then to the computer’s USB port. 1. Open BioExplorer USB dongle key must be plugged in. 2. Resize BioExplorer window For quick access to PN Wiz window behind it Open Training design “BAL4C RH Bipolar” 1. Fill syringe with gel Preparing to […]

Support resource

Enable Device in BioExplorer – Optima 2 USB

Connect USB dongle key. USB dongle key must be plugged in. BioExplorer software will not run without the USB key. Launch BioExplorer BioExplorer is open. No device has been added and no design (protocol screen) has been loaded yet. You should already have run your setup file(s) After you have run your setup file(s) provided […]

Support resource

BioExplorer Manual and resources

BioExplorer Help menu & Tutorials (PDF)  BE’s built-in “manual” compiled as a documentBioExplorer Tutorial html digital manualby Adrian Van DeusenBioExplorer Version – Latest version, your versionDScaler MPEG decoder filters — 64 bit (665 KB)DScaler MPEG decoder filters — 32 bit (677 KB)DivX codec pack (976 KB) (If DVD does not work in Windows 8)Compatibility mode for Windows 7 Windows 10 users can […]