About Wiz Devices Brain-Trainer Wiz User Guide (1.94 MB)Wiz by Pocket Neurobics – User ManualFactory ResetFirmware Update PN Driver Manual Installation (Windows 10 & 11) Windows 10 and 11 require manual installation of the Pocket Neurobics (PN) driver. These installation instructions can also be used for Windows 7 and 8 machines that are not installing […]

Check that you have connected your Wiz to your computer using the USB cable. Not Connected Try the following: Devices changed while recording Flat line signal Link button turns blue When you press the link button down hard and hold it for 2 to 3 seconds it will turn blue and that will activate ultra […]

1. Select 4 Channel mode and Helper Off Settings for BioExplorer Settings for BioEra  2. Connect electrodes to all inputs on the Q-wiz You will need seven total: 4 active, 2 reference and 1 ground. For saline, put all electrode assemblies into a jar of saline solution. For paste, stick all the electrode heads into a jar […]

If you suspect the trouble you are having is with your Q-wiz, there are a couple tests you can do. For EEG:  1) No sensors – test tone; 2) Sensors in conductant- flat line. EEG testing HEG testing

If you think you are having trouble with your Q-wiz EEG, the first test to do is check with no sensors attached. 1. Download the design for testing the Q-wiz Download test design   2. Select and Right-click on the zipped file and select Extract All   3. Open the design: wiz_test_Mode4_EEG_4ch_plus_EIM_OFFSET.bxd 4. Select 4 […]

Not connected

Install Driver After you have run your setup file(s) provided by Brain-Trainer you are ready to connect your biofeedback device (amplifier). You may have already installed a file called pnWirelessDongleDriver or Amplifier setup, etc. If not, it may install automatically following the next steps.     USB dongle key must be plugged in. BioExplorer software will […]